Washer Repair Services in Phoenix Metro
A washer that quits mid-cycle leaves you with a tub of water and a wet load. We repair household washing machines for drainage, filling, leaks, door locks, drive and control faults. We do not replace tub bearings or transmissions, and you should know that before you pay for a visit.
- Service call fee waived with repair
- Top-load and front-load models
- No bearing or transmission replacement
Washer problems we can diagnose
If you can, note the point in the cycle where the trouble starts. It narrows the search quickly.
Won't drain
Water sits in the tub after the cycle ends, or the washer stops with a drain error. The usual places to look are a blocked pump or pump filter, a kinked drain hose and a failed pump or pressure sensor.
Won't spin
Clothes come out soaked. A washer that can't drain won't spin, so we check drainage first, then the lid switch or door lock, the belt or drive, and the controls.
Leaking
Tell us when the water appears: during fill, during the wash or during drain. Each one points somewhere different, among them the inlet valve, the door boot on a front-loader, the pump and the hose connections at the machine.
Not filling or filling slowly
One large manufacturer lists sediment or debris at the inlet filters, low water pressure, crushed hoses and partly open supply valves as common causes. A failed inlet valve is another.
Banging, thumping or grinding
An unbalanced load, worn suspension rods or dampers, or something caught in the pump can all do this. A roar on spin that gets worse with speed often means tub bearings, which we don't replace.
Control and cycle problems
A cycle that stops partway, a display showing a code or ignoring buttons, a door that stays locked when the cycle ends. We test the door lock, sensors and control board to find which one is at fault.
What a washer repair from us includes
Repairs we perform
- Drain pumps and pump filters
- Water inlet valves and fill hoses at the machine
- Lid switches and door locks
- Drive belts and drive motors
- Suspension rods, springs and dampers
- Door boots on front-load washers
- Control boards, sensors and wiring
Work we do not offer
- Tub bearing replacement
- Transmission replacement
- Clogs in the home's own drain line, which need a plumber
Repair the washer, or start looking for a new one
The repair cost comes first, then your decision. A few things tend to settle it.
- Usually worth repairing
- A pump, inlet valve, door lock, belt or door boot on a washer that otherwise runs well. These are contained repairs with a clear end.
- Worth a harder look
- A machine with several faults showing up together, or one where the part you need has become hard to find.
- Not a repair we offer
- Failed tub bearings or a failed transmission. If that's the diagnosis, you can look for a shop that takes on those jobs, or start pricing a replacement.
Service call fee waived with repair.
We tell you the service call fee before your appointment is confirmed. Your technician finds the problem and gives you the repair cost before any work starts. Approve the repair and once it is completed, the fee is waived. Decline it and you pay only the service call fee. If your technician completes the diagnosis and the repair can't go forward, the service call fee still applies and we'll tell you what we found.
Some findings, such as tub bearings, aren't repairs we make. If that's where the diagnosis lands, the service call fee is payable and we tell you what we found.
Handy to know before you call
- The model number, usually inside the lid or door opening, or on the back of the cabinet
- Top-load or front-load
- Any code on the display, and the point in the cycle where it stops
- Whether water is still in the tub
From request to repair decision
Send your request
Tell us the appliance, what it's doing and your ZIP code. It takes about two minutes online, or you can call us.
We call to confirm
A request isn't an appointment yet. Our team calls to go over the fee and work out a time that fits your day.
Diagnosis, then your decision
Your technician tracks down the problem and tells you what the repair will cost. Nothing gets repaired until you say so.
Washer repair questions
My washer stopped full of water. What should I do until you arrive?
Stop running cycles, and if it's leaking, unplug the machine and turn off the hot and cold valves behind it. Leave the water in the tub if you can. It's part of what the technician needs to see.
Is hard water behind my washer problem?
We don't assume so. One manufacturer says inlet screens can collect mineral deposits along with debris, so a slow fill gets a look at the screens. Another's guidance for the same symptom lists sediment, pressure and hoses and doesn't mention hardness. We haven't found a manufacturer that ties hard water to a shorter washer life, so we look at what actually failed.
The washer roars when it spins. Can you fix that?
If the noise builds with spin speed and has been getting worse, the likely cause is the tub bearings, and that's a repair we don't take on. A visit can confirm it, but if the sound matches that description you may want to weigh that before booking.
What should we do with the washer if we're away for months?
Whirlpool and LG both say to unplug it and turn off the water supply while you're gone. Whirlpool says this helps avoid flooding from a pressure surge. One also suggests working the shutoff valves a couple of times a year so they don't seize.
Water is backing up out of the drain pipe behind the washer. Is that the washer?
Usually the washer is doing its job and the home's drain can't keep up. That points to a clog in the drain line, which is a job for a plumber.
Does the maintenance plan lower the repair bill?
On the annual maintenance plan, eligible repair labor is 15% off at the enrolled property and 10% off at other properties on the same account, starting once an eligible paid membership is active. There's no discount on parts.
Washer repair by city
City pages with coverage details, or look up your area. You can also compare every appliance we repair or send a request online.
Also in the laundry room and kitchen
Wet laundry can't wait forever
Tell us what the washer is doing and where you are. We'll call to confirm the fee and a time that fits your day.